TBSTG Type 1 Compatible Replacement Remote Programming Instructions.

Programming Rolling Code Door Openers.

1. Press and release the receiver program button on the power head of your door opener. This small, black, unmarked button is located behind the light lens at the motor head and is nearest the 6-inch antenna wire that extends from the motor head. When pressed, a radio signal indicator light will start blinking red for 30 seconds.
2. After pressing the Learn Code Button once and releasing it, press your remote button three times for your system to accept the frequency and codes it into memory.

Note: Keep the remote you are programming at least 2 feet away from the power head while programming.

1. Press the remote button once more to test the system and then your door should start moving.

For multi-button remotes repeat each step above using one remote button for each different rolling code opener.

To Erase All Codes from Motor Memory.

To deactivate any unwanted or lost remote, first erase all codes: Press and hold the “program” button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote and keypad that you wish to use still.

Buy This Item Now Includes.

Includes a car visor clip, battery and programming instructions

Orders ship the next business day, with a 30-day return policy for your convenience.