• Opener Parts Online Catalog

    • Store
  • Get directions
    Business hours

Opener Parts Online Catalog

2021 Opener Parts Online, Related Door Products, Inc

Categories

Learn Button Location


What is The Chamberlain Learn Button On Your Garage Door Opener and Where Is It

Occasionally, you will have to reset your garage door opener remote or sync your opener to a new remote. To do this you will want to know what the Learn Button on your garage door opener is and how to find it.

The learn button is located on your garage door opener and is used to program new and old remotes, wall mounts and keypads. It is also used to clear the memory of the opener. Clearing it will wipe out all previously programmed devices.

Depending on the make and model opener you have the button could be either Green, Orange, Purple or Yellow. (Older receivers used trinary switches to match the remote's setting).

Where is the Chamberlain Learn Button Located on The Opener

The button is on your opener right above the antenna wire. That wire hangs above the motor head. Some models have the button located on the back of the unit. Others are located on the side. If you have a light on the back of your opener, the button will be underneath the light cover.

How to Open the Light Cover

To access a button that is located under the light cover, you will need to unhook the cover. Most of the time the cover will hang from the opener on a hinge while it is open. On some units the cover may come all the way off.

To open the light cover, you will need to locate the two buttons on either side of the cover. Press the buttons in to release the cover.

The Chamberlain Learn Button Is Used To Program New Devices

Once you find the button on your opener you can use it to program new devices. If you get a new remote or install a wireless keypad you will need to program the two together.

Your opener should have a LED indicator light to communicate to you while you are programming the new devices. When you clear the memory on the opener, the LED will light up and stay that way for 30 seconds. Once it goes off, you know the unit is cleared out. Then you will need to push the learn button again to program it to the new devices.

Using the Learn Button

  1. Press and release the learn button on the opener's motor unit. The button's indicator light will illuminate continuously for 30 seconds.
  2. During those 30 seconds, press down and hold the button on the handheld remote control you want to use to operate the garage door.
  3. When the motor unit's light begins blinking, release the remote button. If the unit doesn't have a lightbulb, you'll hear two clicks instead.
  4. Test the remote to make sure it activates the door. If not, repeat the process.





Share Tweet Pin
© 2021 Opener Parts Online, Related Door Products, Inc Report abuse
Powered by